The Medusa Trust

Special Equipment Fitted for D-Day

GEE System (QH)

Medusa was equipped with the Gee navigator system (referred to by the navy as "QH"). The system was originally developed for precision bombing for the RAF and worked by measuring time intervals between pulses received from three locations. The receiver had plug-in tuning units and Medusa was provided with an RF27 tuning unit capable of receiving special frequency (XF) transmissions from the Southern GEE Chain. Special fine lattice charts covering the assault area were provided sealed, for security. They were not to be opened before receipt of code message "OPEN ONWEST/O".

DECCA System (QM)


The Decca system (referred to as "QM" by the Royal Navy) was developed prior to D-Day and tested in secrecy to reduce the chance of it being jammed on D-Day. For D-day, 30 units were hand built, Medusa and ML1383 were the only two HDMLs to have them fitted. It is believed that Medusa and ML1383 went out immediately prior to D-Day to test the system. Special fine lattice charts covering the assault area were provided sealed for security. They were not to be opened before receipt of code message "OPEN ONWEST/O".

Radio Beacon 78T

This homing beacon was to be switched on when the beacon position was reached and transmitted on 340 degs True. These transmissions continued until H Hour (13 hours being the approximate battery life of the device). Type 78T transmissions can be picked up by Radar Types 286 and 291 fitted to some approaching units at 15 miles (if within the beam) or at less than 4 miles (outside the beam). Receivers are tuned to 214 MHz producing a display of a string of needle-like pulses giving a code letter at approximate one minute intervals. HDML 1387 transmitted the letter "D". We have been unable to locate detail of the beacon equipment but believe it was a modified Rebecca/Eureka set that was developed for homing aircraft to drop zones.

FH-830 Acoustic Beacon


These sea-bed acoustic beacons were laid by either ML 147, ML 151 ML 198 in position 50 05N 000 46 44W during Operation Enthrone and came into operation on a timer. Type 134 Asdic received the beacon transmissions allowing the boat to be conned into position over the beacon. HDML 1387's beacon was set on High Tone with a four second repetition rate

 

Standard equipment

Radar, type 291

the naval type 291 radar was an adaptation of the RAF ASV radar fitted in Coastal Command aircraft for        

submarine spotting.  It was a metric wave device operating on approximately 214 MHz.  The antennae were fixed yagi arrays on a topmast, later versions allowed a degree of training from a hand wheel in the radio room.  The display consisted of a single vertical line on the screen and targets would show as a horizontal deflection of the line, the further up, the greater the range.  It took some skill to operate but would detect surface targets at a few miles and aircraft at up to 20 miles.

associated with the radar was an IFF transponder which allowed the radar to identify which targets were friendly and which enemy, similarly the equipment identified ML1387 as a friendly to other allied vessels and aircraft.

 

 

 

 

 

Type 134 ASDIC

The type 134 ASDIC consisted of a dome below the forward crew space, some electronics in the chart room and a paper chart display in the chart room on the forward starboard side.  The dome hung under the keel and projected up into the vessel through a bronze "stand pipe" which was fixed to the keel.  Early versions just looked forward but later had the ability to train.

The display unit was a paper recorder with a mechanical device on top which would compute the correct time to drop depth charges.  The signal to drop was by pushing a large button which sounded a buzzer at which point one of the crew rolled a depth charge over the side.

 

 

 

W/T equipment

ML1387 carried a transmitter/receiver package type TW12C, manufactured by the Marconi company and based on a civilian system intended for small coasters and trawlers.   This would provide both morse and speech communication and ran off the vessels 24V DC system via a rotary converter.  The frequency coverage was 375-500KHz (morse) and 1200-3000 KHz (morse and speech) although later models covered up to 8820 KHz for increased range.

Transmitter TW12C

The transmitter used 3 valves, a type NT40 as an oscillator, a further NT40 as a modulator and an NT39 as an output amplifier. The power output was 50W on CW (morse) and 30W on R/T (speech)

Receiver Type 384E

The receiver is a late 20s design and predates the Marconi CR100 set which was widely used.  It consists of 4 valves, to ARS8 as RF amplifiers, an NR42 as a regenerative detector and an NR39 as an audio amplifier.

The Medusa Trust has an example of the 384 and would like to obtain a TW12 in order to refit the radio room.